Aeg-Electrolux HD634170NB Manual de usuario descargar pdf (Pagina 17)

Make sure that the gas supply

pressure of the appliance obeys

the recommended values. If the

supplied pressure has not the

specified value, it is necessary to

assemble a proper pressure reg-

ulator in compliance with the

standard UNI EN 88. For Liquid

Gas (LPG) the use of pressure

regulator is allowed only if they

are in compliance with UNI EN

12864. The adjustable connec-

tion is fixed to the comprehen-

sive ramp by means of a threa-

ded nut G 1/2". Screw the parts

and tighten everything with tef-

lon tape, if necessary, to get the

right direction.

A

B

C

A)

End of shaft with nut

B)

Washer

C)

Elbow (if needed)

Rigid connection:

Carry out connection by using metal rig-

id pipes (copper with mechanical end)

(UNI-CIG 7129).

Flexible connection:

Use a flexible pipe in stainless steel

(UNI-CIG 9891) with a maximum length 2

m.

When installation is complete,

make sure that the seal of each

pipe fitting is correct. Use a

soapy solution, not a flame!

8.2 Injectors replacement

1.

Remove the pan supports.

2.

Remove the caps and crowns of the

burner.

3.

With a socket spanner 7 remove the

injectors and replace them with the

ones which are necessary for the

type of gas you use (see table in

"Technical Information" chapter).

4.

Assemble the parts, follow the same

procedure backwards.

5.

Replace the rating plate (it is near

the gas supply pipe) with the one for

the new type of gas supply. You can

find this plate in the package sup-

plied with the appliance.

If the supply gas pressure is changeable

or different from the necessary pressure,

you must fit an applicable pressure ad-

juster on the gas supply pipe.

8.3 Adjustment of minimum

level

To adjust the minimum level of the burn-

ers:

1.

Light the burner.

2.

Turn the knob on the minimum posi-

tion.

3.

Remove the knob.

4.

With a thin screwdriver, adjust the

by-pass screw position.

A

A)

The by-pass screw

• If you change from natural gas G20 20

mbar to liquid gas, fully tighten the

adjustment screw in.

• If you change from liquid gas to natu-

ral gas G20 20 mbar, undo the by-pass

screw approximately 1/4 of a turn.

WARNING!

Make sure the flame does not go

out when you quickly turn the

knob from the maximum position

to the minimum position.

8.4 Electrical connection

• Make sure that the rated voltage and

type of power on the rating plate

agree with the voltage and the power

of the local power supply.

ENGLISH 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

Comentarios a estos manuales

Sin comentarios