Aeg-Electrolux 6310K-M Manual de usuario descargar pdf (Pagina 6)

6

Glass ceramic surface

The glass ceramic surface has four

zones. When a zone is turned on it

is illuminated at various intervals

depending on the setting chosen.

Even at the highest setting the zone

is disconnected occasionally to

ensure that the surface is not over-

heated.

The glass is hard, and has been

tempered to withstand heat, cold

and temperature shocks. But like all

glass it is sensitive to impact. Do

not stand on the glass ceramic

surface - it cannot withstand

abnormal loads.

Zones

There are tree single zones and one

double zone.

Pilot light

Pilot light is activated when either

of the plates are turned on, and will

remain on until the plates are

switched off.

Residual-Heat indicator

Each plate has a residual heat

indicator which remains on as long

as the temperature of the plate

exceeds 80˚C, even if the plate is

switched off.

15

Minimum distance

to wall:

150 mm

Minimum distance

to wall (non-

flammable material):

50 mm

Reinforcement

beams

Mounting

Caution: In order to avoid a hazard this

appliance must be installed according to

these instructions for installation

The appliance unit can be mounted in

any type of kitchen with a work top

whose thickness is between 28 mm and

40 mm.

Clearance

The distance between the top side of the

work top and the carpentry underneath

must be at least 47 mm.

Fixing

Screw the fixing brackets out to such an

extent that they can be turned in under

the work top. Tighten the brackets on to

the work top with an ordinary

screwdriver.

Cut-out measurements

One rectangular hole is sawn out for the

appliance combination chosen.

The depth of the cut-out for any unit is:

490 mm

Length of hole = sum of all units`

externally measured length, less 20 mm.

Mounting of Reinforcement

Beams

A reinforcement Beam, with supporting

flanges at each end, is included with

each two-burner unit. For unit

combinations, a reinforcement beam

must be used between each unit.

Min. 47 mm

1 2 3 4 5 6 7 8 9 10

Comentarios a estos manuales

Sin comentarios