Aeg-Electrolux 61402G-M Manual de usuario

61402 G61502 GInstruction Booklet Gas HobGBIE

10OVERALL DIMENSIONS Width: 580 mmDepth: 500 mmCUT OUT DIMENSIONS Width: 550 mmDepth: 470 mmSUPPLY CONNECTIONS Gas:R 1/2 inch (1/2 inch male) Rear rig

11BURNER RAPID SEMI-RAPIDAUXILIARYPOSITION M AX MIN M AX MIN M AX MIN NOMINAL THERMAL POWER kW 3.0 0.75 2.0 0.45 1.0 0.33 NOMINAL F

12Important Safety RequirementsThis hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations(Current Edition) and th

13InstallationIMPORTANTThis hob must be installed by a competent person to the relevant Gas Standards.Any gas installation must be carried out by a re

14600 MIN.LocationThe hob may be located in a kitchen, akitchen/diner or bed sitting room, but not ina bathroom, shower room or garage.Ensure that the

15Fitting the Hob into the WorktopBefore fitting the hob into the cut out, a sealing gasket supplied with the hobmust be fitted to the edge of the cut

16Building over a kitchen unit withdoorProper arrangements must be taken in designing thefurniture unit, in order to avoid any contact with thebottom

17Electrical ConnectionsAny electrical work required to install this hob should be carried out by a qualifiedelectrician or competent person, in accor

18Permanent ConnectionIn the case of a permanent connection, it is necessary that you install a double pole switchbetween the hob and the electricity

19Fault FindingPreliminary Electrical Systems CheckSTARTIsolate applianceand carry out:A: Earth Continuitycheck. Has inlet fuse blown?Carry out:C: Pol

2ContentsImportant Safety Information ... 3Instructions for the User

20A. EARTH CONTINUITY CHECKAppliance must be electrically disconnected - meter set on W (Ohms) x 1 scale andadjust zero if necessary.— Test leads from

21Check gas supply atburnerIgnition System / Gas IgnitionYESCheck plug top fuse andreplace if necessaryCheck polarity and earthcontinuity of supply po

22CommissioningWhen the hob has been fully installed it will be necessary to check the minimum flame setting.To do this, follow the procedure below.1)

23Conversion from Natural Gas to Liquid GasIMPORTANTThe replacement/conversion from natural gas to LPG should only be undertaken bya competent person.

24Guarantee/Customer ServiceStandard guarantee conditionsWe, AEG-Electrolux, undertake that if within 12 months of the date of the purchase this AEG-E

25Service and Spare PartsIn the event of your appliance requiring service, or if you wish to purchase spare parts, pleasecontact your local Service Fo

26This appliance is guaranteed by Electrolux in each of the countries listed at the back of this usermanual, for the period specified in the appliance

27

35687-8103 11/07 R.0 Subject to change without noticewww.aeg-electrolux.co.uk

3Important Safety InformationYou MUST read these warnings carefully before installing or using the hob. Ifyou need assistance, contact our Customer Ca

4Keep this instruction book for future reference and ensure it is passed on toany new owner.These instructions are only valid for countries whose ide

51. Hob Top2. Rapid Burner3. Semi-rapid Burner4. Auxiliary Burner5. Control knob for back right burner (semi-rapid)6. Control knob for back left burne

6Hob burners control knobs The symbols on the knobs mean that :  there is no gas supply there is maximum gas supply there is minimum gas supplyLight

7Burner minimum maximumdiameter diameterRapid 160 mm 240 mmMedium (semi-rapid) 120 mm 220 mmSmall (auxiliary) 80 mm 160 mmAs soon as a liquid starts b

8Before any maintenance or cleaning can be carried out, you mustDISCONNECT the hob from the electricity supply.The hob is best cleaned whilst it is st

9Something Not Working?If the hob is not working correctly, please carry out the following checks beforecontacting your local Service Force Centre.