Aeg-Electrolux HK764400IB Manual de usuario descargar pdf (Pagina 14)

Problem Possible cause and remedy

The residual heat indicator does

not come on.

The cooking zone is not hot because it operated only for a short

time. If the cooking zone is supposed to be hot, speak to the After

Sales Service.

Heat setting alternates The Power management is active. See the section Power man-

agement.

A sound operates and appliance

starts and stops again. After 5

seconds one more sound oper-

ates.

You covered . Uncover the sensor field.

comes on

• The automatic switch-off operates. Stop the appliance and

start it again.

• Overheating protection for the cooking zone operates. Switch

off the cooking zone. Switch on the cooking zone again.

comes on

• No cookware on the cooking zone. Put cookware on the cook-

ing zone.

• Not correct cookware. Use the correct cookware.

• The diameter of the bottom of the cookware is too small for

the cooking zone. Move cookware to a smaller cooking zone.

and number come on.

There is an error in the appliance.

Disconnect the appliance from the electrical supply for some

time. Disconnect the fuse from the electrical system of the house.

Connect again. If

comes on again, speak to the after sales

service.

comes on

There is an error in the appliance, because a cookware boils dry

or you use not correct cookware. Overheating protection for the

cooking zone operates. The automatic switch-off operates.

Switch off the appliance. Remove the hot cookware. After ap-

proximately 30 seconds switch on the cooking zone again.

should disappear, residual heat indicator can stay. Cool

down the cookware and check it with the section Cookware for

the induction cooking zone.

There is no signal when you

touch panel keys

The signals are off.

Switch on the signals.

If you tried the above solutions and cannot repair the problem, speak to your dealer or the

Customer Care Department. Give the data from the rating plate, three-digit-letter code for

the glass ceramic (it is in the corner of the cooking surface) and an error message that

comes on.

If you operated the appliance incorrectly, the servicing by a customer service technician or

dealer will not be free of charge, even during the warranty period. The instructions about

the customer service and conditions of guarantee are in the guarantee booklet.

What to do if…

1 2 ... 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios

Aeg-Electrolux HK764400IB Manual de usuario Pagina 14

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Aeg-Electrolux HK764400IB