Aeg-Electrolux HK854400IS Manual de usuario

HK854400ISUser manual Ceramic glass inductionhob

•Selection of the cooking zone (if more than 1 cooking zone operate): touch again and again until the indicator of a necessary cooking zone comes on.•

OffSound Control (Switching off and on the sounds)Switching off the soundsSwitch off the appliance.Touch for 3 seconds. The displays come on and go o

Examples of cooking applicationsThe data in the table is for guidance only.HeatsettingUse to: Time Hints 1Keep cooked foods warm as re-quiredCover1-3

Removing the dirt:1. –Remove immediately: melting plastic, plastic foil, and food containing sugar. Usea special glass ceramic scraper. Put the scrape

Problem Possible cause and remedy comes onThere is an error in the appliance, because a cookware boils dryor you use not correct cookware. Overheating

15

www.aeg-electrolux.com/shop 892935717-B-042010

Thank you for choosing one of our high-quality products.To ensure optimal and regular performance of your appliance please read thisinstruction manual

WARNING!Start the child safety device to prevent small children and pets from an accidental activationof the appliance.Safety during operation• Remove

Safety instructionsWARNING!You must read these!Make sure that the appliance is not damaged because of transportation. Do not connect adamaged applianc

• For the four corners of the rabbet the ends of the sealing tapes must be cut into mitres.Do not bond the ends over one another.• Bond the sealing ta

If you use a protection box (additional accessory),the front ventilation space of 5 mm and protectivefloor directly below the appliance are not neces-

sensor field function6a heat setting display shows the heat setting7a control bar to set the heat setting8 / increases or decreases the time9selects

Automatic Switch OffThe function stops the hob automatically if:• all cooking zones are off.• you do not set the heat setting after you start the hob.

2. Immediately touche the necessary heat setting. After 3 seconds comes on in thedisplay.To stop the function change the heat setting.Switching the