Aeg-Electrolux HK854400FS Manual de usuario Pagina 13

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 16
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 12
WHAT TO DO IF…
Problem Possible cause and remedy
You cannot start the appliance
or operate it.
You touched 2 or more sensor fields at the same time. Only
touch one sensor field.
There is water or fat stains on the control panel. Clean the
control panel
Start the appliance again and set the heat setting in 10 sec-
onds.
The child safety device or key lock or Stop+Go operates. See
the chapter Operating the appliance.
A sound operates when the ap-
pliance is off.
You covered one or more sensor fields. Uncover the sensor fields.
The residual heat indicator does
not come on.
The cooking zone is not hot because it operated only for a short
time. If the cooking zone is supposed to be hot, speak to the After
Sales Service.
Heat setting alternates The Power management is active. See the section Power man-
agement.
A sound operates and appliance
starts and stops again. After 5
seconds one more sound oper-
ates.
You covered . Uncover the sensor field.
comes on
The automatic switch-off operates. Stop the appliance and
start it again.
Overheating protection for the cooking zone operates. Switch
off the cooking zone. Switch on the cooking zone again.
comes on
No cookware on the cooking zone. Put cookware on the cook-
ing zone.
Not correct cookware. Use the correct cookware.
The diameter of the bottom of the cookware is too small for
the cooking zone. Move cookware to a smaller cooking zone.
and number come on.
There is an error in the appliance.
Disconnect the appliance from the electrical supply for some
time. Disconnect the fuse from the electrical system of the house.
Connect again. If
comes on again, speak to the after sales
service.
comes on
There is an error in the appliance, because a cookware boils dry
or you use not correct cookware. Overheating protection for the
cooking zone operates. The automatic switch-off operates.
Switch off the appliance. Remove the hot cookware. After ap-
proximately 30 seconds switch on the cooking zone again.
should disappear, residual heat indicator can stay. Cool
down the cookware and check it with the section Cookware for
the induction cooking zone.
There is no signal when you
touch panel keys
The signals are off.
Switch on the signals.
What to do if…
13
Vista de pagina 12
1 2 ... 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios