AEG Electrolux ERC 34292 S Guía de uso y cuidado descargar pdf (Pagina 22)

COOKING ZONE HEATS FOOD TOO HOT OR NOT HOT ENOUGH

• Incorrect power level setting. Adjust the power level setting higher or lower and refer

to recipe for guidance and adjust accordingly.

FOOD DOES NOT HEAT EVENLY

• Lightweight or warped pans were used. Be sure to use good quality cookware.

• Use only at bottom, evenly balanced medium or heavyweight cookware. Heavy and

medium weight pans heat evenly. Because lightweight pans heat unevenly, foods may

burn more easily (See pages 11 to 13 for further information).

• Adjust Cooking Zone power level setting until the proper amount of heat is obtained.

POOR COOKING RESULTS

• Many factors affect cooking results. Adjust the recipe’s recommended power levels or

cooking times.

• Cookware is too lightweight or warped. Use heavier quality cookware so foods being

prepared may cook more evenly.

COOKTOP ZONE CONTROLS DISPLAY "E0" AND A 2

DIGITS ERROR CODE

• Induction Cooktop main control has detected a fault or error condition. Try turning

electrical power supply OFF and back ON to cooktop in order to reset Cooktop main

controls. If fault recurs, record fault number and turn power supply to Cooktop OFF.

COOKING ZONE LED CONTINUOUSLY FLASHES F

• Induction Cooktop pan detection sensors do not see the correct cookware. Test with a

magnet to be sure cookware is made with Induction compatible material.

• Cookware has been removed from the Cooking Zone without turning the Cooking Zone

OFF. Place cookware back on to the Cooking Zone or if nished cooking turn of the

affected Cooking Zone.

• Cookware is not centered over the Cooking Zone properly. Refer to page 12 for correct

cookware placement.

SolutionstoCommonProblems

1 2 ... 17 18 19 20 21 22 23 24

Sin comentarios

AEG Electrolux ERC 34292 S Guía de uso y cuidado Pagina 22