Aeg-Electrolux 6310K-M Manual de usuario descargar pdf (Pagina 8)

8

Protection of the glass

ceramic surface

A protective film should be applied

to the glass ceramic surface before

use. This will make it easier to

clean the surface, as well as

preventing substances from being

burnt onto the surface.

This is what to do:

1. Pour a few drops of ceramic

cleaning detergent such as

vitroclen onto a piece

of kitchen roll and rub the

detergent into the entire surface.

2. Polish the surface with a clean

cloth until it is dry.

25

Service

Sympton

The hob is not working

The hob becomes hot

The fuses keep blowing

The cooking zones do not heat

sufficiently

Solution

Check your earth leak circuit breaker.

Check fuses.

The ceramic hob will reach a

temperature of 80˚C. It may, however,

become even hotter if you use cooking

utensils with uneven bases or which

does not match the size of the cooking

zone.

Too many electrical appliances may be

in use at the same time. If the hob is

connected to a 10 Amp fuse group, the

risk of overloading will be

considerable.

The cooking utensils must match the

size of the cooking zone. Check that

the cooking utensils have level bases

by holding them against the edge of the

work top, for example. Bring a litre of

water to the boil in a saucepan with a

lid. The cooking zone should be

adjusted to the highest setting.

The boiling time on the 12 cm cooking

zone is approx. 25 min.

The boiling time on the 14 cm cooking

zone is approx. 13 min.

The boiling time on the 18 cm cooking

zone is approx. 10 min.

Before calling service – Technical advice

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comentarios a estos manuales

Sin comentarios